Any shaft recommendations for a Sonartec TRC 3 Wood? Just bought the head, and am looking for a good shaft to put in it. My 5 iron distance is 195, and I am a hitter. I plan on using it off the tee on tight par fours, and for reaching long par 5's. I hope to carry it at least 250.
The TRC is a great "hybrid" type club that has been discontinued. I think it is actually a far better performing and looking club than the Mid. I found success with an Aldila NV-95 "S" in my TRC. I also added a half inch to gain a few extra yards for par 5 reachability. So bottom line, I would stay with a slightly heavier graphite gram weight in the 85-95 zone and mid flex point. This would match the weight and characteristics of the TRC design. IMO
The TRC is a great "hybrid" type club that has been discontinued. I think it is actually a far better performing and looking club than the Mid. I found success with an Aldila NV-95 "S" in my TRC. I also added a half inch to gain a few extra yards for par 5 reachability. So bottom line, I would stay with a slightly heavier graphite gram weight in the 85-95 zone and mid flex point. This would match the weight and characteristics of the TRC design. IMO
When you refer to the Mid is that the Md Transition club?
PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN" "http://www.w3.org/TR/html4/loose.dtd">
ERROR: The request could not be satisfied
504 Gateway Timeout ERROR
The request could not be satisfied.
We can't connect to the server for this app or website at this time. There might be too much traffic or a configuration error. Try again later, or contact the app or website owner.
If you provide content to customers through CloudFront, you can find steps to troubleshoot and help prevent this error by reviewing the CloudFront documentation.
Generated by cloudfront (CloudFront) HTTP3 Server
Request ID: CYJ0yH9s5o_i4DhSHLfytivLbkaqW8M2qwPp81hdG_kzbywkxZSQtg==
Linear Mode
